Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may discover that your garage door opener has been providing you problems, so you require to fix it. You can repair it by replacing a circuit board, a photo-eye sensing unit, the primary drive equipment, or the set-limit switches. You can also examine if the safety and security sensors are functioning properly.

Replacing a circuit card

Changing a circuit card for your garage door opener requires a couple of actions as well as tools. First, you need to switch off the circuit breaker as well as separate any cables. Next off, open up the motherboard cover. This will certainly help you to detect the trouble and also determine if you need a new board. Next, get rid of the old board and also its cord adapters.

You can then proceed to replace the circuit card. The replacement process is easy and takes about 10 minutes. A new circuit board will set you back regarding $80. To shield your new motherboard from power surges, you can purchase a surge guard.

Changing a photo-eye sensing unit

Replacing a photo-eye sensing unit can be a fairly simple task. First, eliminate the sensing unit from the door and also ensure it is positioned appropriately. If the sensing unit is angled at all, it may not be getting the right signal, which might be creating the strobe lights. If you observe that the photo-eyes are out of placement, you may require to have actually a service technician come and deal with the issue.

The photo-eye sensing unit contains 2 items that place on the outside of the door tracks as well as toward the flooring. The image eyes will have a small LED light and must be solid in color. If the light is blinking, its likely the photo-eye is defective and will certainly require to be replaced.

Changing a primary drive gear

To change a garage door opener major drive gear, start by getting rid of the cap from the chain sheave. Next, remove the two screws holding the drive gear to the gear setting up. Now, you can unfasten the 3 tension pins. Press them from both sides and afterwards eliminate them. After that, disconnect the three cables from the garage door opener electric motor. These wires ought to be white, red, and blue.

Once you have actually gotten rid of the old equipment, install a new one. Make certain to oil it well. Place the new equipment into the shaft, making sure to line up the mounting holes. Make sure the equipment and sprocket assembly are located properly to make sure smooth operation. Next off, utilize a hammer as well as a nail to drive a pin into the brand-new gear.

Adjusting the set-limit switches

The very first point you need to do if your garage door is not working appropriately is to check the set-limit switches. You may need to readjust them to make sure that the door closes earlier or quits before it gets to the flooring. You can check this by looking at your garage doors guidebook or online.

To adjust the set-limit buttons, youll require a screwdriver or socket. Adjust the handle clockwise or counterclockwise till the door moves up as well as quits, or minimizes its range. To check for proper traveling range, measure the space from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Key St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *

Back To Top